A cosmetologist therapist / aesthetic can basically use two types of hot wax. Traditional warm wax is named after the temperature, and it is very warm on the skin. And New Style Non-Striped Wax
Conventional Hot Wax With the fingers shown in Figure 8, create additional layers to build the thickness and ensure that all hairs are wax removed. The wax heavily affects the hairs, but when it cools down, it is hard on the skin and is often very difficult to remove. In some cases, it feels like a spatula is being applied to the wax to cut it off.
Most therapists are now moving to the new style of Hot Wax, originally a French chemist in the early 80's. This style of wax is different from non-Strip, Brazilian, Peelable, Hot Film etc. All of them work essentially the same way and have a much lower melting point, which makes the customer more comfortable.
Before starting waxing, check the area to be waxed, look at the hair growth directions and, if necessary, if the hair is too long (usually over 1 cm long) with a few scissors. 2nd gear (6 mm) But not shorter.
Before applying wax, clean the skin with a suitable cleanser with a cotton pad. Then prepare the waxing area with very little pre-wax oil. There are now several wax companies, which are usually jasmine scents. Instead of using talc, the use of oil is a much better way of preparing the skin, creating a lipid barrier between the skin and the wax, which means it suits hair and not the skin. As a result, wax removal is much easier and more convenient for the customer. If the wax slides when you use too much oil, wipe the area with a ribbon to remove any excess oil and leave the perfect amount.
Wax Screw a small amount of the pot on the disposable wooden spatula and apply the wax to the hair growth direction as it would give you a ribbon wax. The line should be relatively thin but not too thin because it will be broken when removed. There is a small art that has the right thickness, and each wax is slightly different so you can play with yours to practice it. If the wax is too thin, you can pull a little over the top to thicken it. The length of the ribbon can be lengthened, slightly overlapped and continued down.
To save time, you can apply a second tape on the skin with the first tape but not touching it. After you have finished this tape, the first one will be ready to be removed.
Before removing the wax, just touch where the thickest is to make sure it is set and then start the end of the strip. End of the finger or spatula. Now confirm the skin to keep the tape tightly tight if a long ribbon is not removed during a pull. Instead, remove the short section, move the stiffener's hand close to the end of the wax and remove the skin. Continue this on the tape. If removed, hit your hands in the skin or rub it at once to calm it down.
If all hair is removed, take large amounts of oil and remove with detergent with a cotton pad. This removes sticky residues and prepares the skin for the next wax cream or products.
With very short stubborn hairs, the wax is applied to hair growth and is removed in the usual way. This can help lift the fibers into the wax to tighten them tightly.
Source by sbobet
sbobet thai
sbobet thailand